Skip to main content

Installation of the overhauled brakes

I could find the time on Sunday and started the installation of the overhauled brakes.
First of all I installed the new brake pads.  I bought them with 6,000JPY for a set of front and rear when shop did the sale.  I thought it quite reasonable.


Nice!

In the next I replaced the brake hoses with the stainless-mesh lines


15mm flare nut wrench was necessary to remove the hoses but I couldn’t find it (I think 15mm is not popular size).  So, I found a set of crow foot wrench at a tool shop and bought it.


I could loosen the nut only little by little.  But it seemed useful in combination with the extension bar to turn the nut if it located at complicated position.


Overhauled caliper and new stain mesh brake lines were installed.


The stainless mesh brake lines were not showier than I thought.


Now the caliper and brake hose looked fine.  But other parts were not beautiful!  I should grind the surface of the brake rotor.


(My original blog was written on 27th May 2008)
Labels:

Comments

Post a Comment

Popular posts from this blog

Clutch master cylinder overhaul #2: tough match

I disassembled the removed clutch master cylinder. And I found that the piston was heavily rusted. I tried to hit it with a hummer , Pushed the piston using the vise clamp like this.  However , the piston was heavily sticking by rust and it could not to be moved today. The brake master cylinder was replaced in the past , however , the clutch master cylinder was not.  Therefore , the condition of the clutch master cylinder might be worse. Tentatively , I would spray the rust-penetration lubricant from both sides of the piston and try again in a few days. If it doesn ’ t work , I would give up the overhaul and order the new part. ( My original blog was written on 2nd July 2009 )
Post a Comment
Read more

Tip to repair rubber parts

I disassembled the rear axle before.  There had been no progress on it because I started the repair of the fuel tank during my summer holiday. While painting the fuel tank , I repaired the torn rubber boot of the parking brake wire. I guessed it didn ’ t cost high because it was small rubber part.  But I wanted to try the repair method I read on the magazine article before. This was the condition before the repair.  The rubber was torn apart and separated almost. I used this self-adhesive type butyl tape.  I pasted lots of small pieces of the butyl tape on the back side of the rubber boot.  As time goes by , these tapes would melt and stick together.  After this I applied plenty of adhesive “ Super X Black ” on the rubber boot.  On the magazine of MOTO MAINTENANCE , I read the article that the motorcycle seat was repaired with this method.  So , I wanted to try it. After drying 1 day , it became like this....
2 comments
Read more