Skip to main content

Rear brake caliper pistons removal

I got on the momentum and started the overhaul of the rear calipers.


At first I removed the right and left rear calipers.




And I started to remove the pistons from the left side caliper.


It took time little because the piston of the rear caliper had difference from front one, however, I managed to remove it.
It was not an easy job despite I already did several time.  Although work time was getting shorter gradually.


The calipers were very dirty of course!  I had to start cleaning again.
But one good thing was that rear caliper was smaller than front.


(My original blog was written on 19th Feb. 2008)
Labels:

Comments

Post a Comment

Popular posts from this blog

Tip to repair rubber parts

I disassembled the rear axle before.  There had been no progress on it because I started the repair of the fuel tank during my summer holiday. While painting the fuel tank , I repaired the torn rubber boot of the parking brake wire. I guessed it didn ’ t cost high because it was small rubber part.  But I wanted to try the repair method I read on the magazine article before. This was the condition before the repair.  The rubber was torn apart and separated almost. I used this self-adhesive type butyl tape.  I pasted lots of small pieces of the butyl tape on the back side of the rubber boot.  As time goes by , these tapes would melt and stick together.  After this I applied plenty of adhesive “ Super X Black ” on the rubber boot.  On the magazine of MOTO MAINTENANCE , I read the article that the motorcycle seat was repaired with this method.  So , I wanted to try it. After drying 1 day , it became like this....
2 comments
Read more

Clutch master cylinder overhaul #5

Regarding the clutch master cylinder which I repaired the hole at piston with solder , one of my friend advised me that the solder might not be hard enough.  Therefore , I tried the repair again in another way. Disassembled the clutch master cylinder again. Now I can do it very quickly because I disassembled brake master and clutch master cylinders many times J Heated and removed the solder at the piston hole. I used the soldering iron instead of the burner because I heard giving too much heat on piston should be avoided. In this time , according to the advice from my friend , the repair method is to screw in the thread with strong adhesive into the hole , then grind the thread head to make the piston surface flat.  In order to do it I bought bolts and a grinding stone at the hardware store. Cutting the bolt to adjust the length to fit the hole depth.  Engrave the minus groove at the cut bolt head to make screwing in possible ...
Post a Comment
Read more