Skip to main content

Assembly of the rear parking brake

After long time I worked for the fuel tank, now I have come back to the rear axle.
Since I had backache, I did a continuation of the assembly of the wire linkage of the parking brake at the rear axle which had been interrupted before halfway.
A long time passed from the time I disassembled before, so I forgot how I could assemble them.


Therefore, I looked for the parts list and assembled the linkage referring to the illustration in the parts list.




I couldn’t complete the assembly on this day because it was necessary to fix the hub with a vice in order to set the springs.



(My original blog was written on 1st Nov. 2008)
Labels:

Comments

Post a Comment

Popular posts from this blog

Clutch master cylinder overhaul #2: tough match

I disassembled the removed clutch master cylinder. And I found that the piston was heavily rusted. I tried to hit it with a hummer , Pushed the piston using the vise clamp like this.  However , the piston was heavily sticking by rust and it could not to be moved today. The brake master cylinder was replaced in the past , however , the clutch master cylinder was not.  Therefore , the condition of the clutch master cylinder might be worse. Tentatively , I would spray the rust-penetration lubricant from both sides of the piston and try again in a few days. If it doesn ’ t work , I would give up the overhaul and order the new part. ( My original blog was written on 2nd July 2009 )
Post a Comment
Read more

Clutch master cylinder overhaul #3

I was still struggling with the sticking piston of the clutch master cylinder. I thought I should give up and look for the new part for the replacement.  And to for my curiosity , I started to destroy and disassemble the clutch master cylinder piston by drilling. When I was drilling the piston halfway , I didn ’ t have any specific idea , however , I thought to tap the piston to make the thread.  I started to turn the tap handle , and I felt the feeling that the piston was moved.  So , I tried to pull it , and then suddenly the piston was removed from the cylinder. Finally I could extract the rusty piston! I observed the extracted piston.  It looked there was no risk of the leakage of the fluid because the hole I made in the piston was not penetrated.  Thinking the function that this part only holding the rod connected with the clutch pedal , it could be reused if the hole would be filled by the hard material. However , be...
Post a Comment
Read more